This is a great looking untouched Confederate cavalry saber! This is the classic unmarked version that has lovingly been nicknamed by collectors as the "Dog River" Confederate cavalry saber that is patterned after the U.S. model 1840 cavalry known as the "wristbreaker". They get this nickname because some of the unmarked cavalry sabers were made by the factory on the Dog River in Georgia. The fact is that most of the swords that are unmarked with this nickname were made throughout the south at arsenals and retailers both large and small. This particular design has long been attributed to the Richmond, Virginia firm of Boyle & Gamble. They are easily recognizable because the blade is made flat on each side compared to most of the swords that have the fuller groove running down the middle. This one has a beautiful full-length blade that measures 33 inches. It has the hand hammer marks that are a classic trait of a Southern made edged weapon. The guard and pommel cap have a thick, beautiful untouched patina all over. You can see the pebble like grain pattern to the hand guard that was cast in a sand mold at the Southern maker's shop. It also has a small "B" letter scratched into the inside of the brass guard. The handle still retains the original wooden core as well as some of the leather and tightly wrapped wire wrap. You can tell when you look at the pommel cap that this beauty has never been apart or worked on. If you have wanted a true Southern made cavalry saber that doesn't cost ten thousand dollars then this one is for you.